Imported CNC machining center should follow how the operating process

Imported CNC machining center application is about the quality of spare parts processing, thus, cnc hardware processing standardized operating process can help us reasonably improve the yield rate. The general operating process is shown below.

1、Start up in advance preparation

CNC lathe in each start-up or according to the variable calibration, first Custom Precision CNC Machining  cnc machining factory back to the CNC lathe reference zero position (i.e. back to zero), so that the CNC lathe has a standard part for its actual operation afterwards.

2、Clamping workpiece

Workpiece should be cleaned up before clamping each surface, not to be stained with oil, iron pin and dust, and use thwart (or grinding stone) to remove the burrs on the surface of the workpiece.

Clamping with high speed rail cars must be polished by CNC grinding machine each surface, so that it is smooth and flat. Code iron, nut must be firm, can be stable clamping workpiece, for some difficult to clamp small workpiece can be immediately clamped on the tiger; machine table should be clean and tidy, no iron pin, dust, oil stains; pad block generally put into the coers of the workpiece, the span of the workpiece is too large need to put in the middle of the contour pad block.

3、The workpiece touch number

The workpiece can be clamped with the number of touches to carry out the number of touches to determine the production and processing reference position, the number of touches can be optical and foot type two. There are two kinds of ways to touch the number and side touching the number in the division

4、Prepare all the tools according to the safety operation procedure

cnc machining price according to the program to write the safety operating procedures of the tool data information, change the tool to carry out production processing, let the tool to touch the relative height measuring device placed on the reference point, when the green light on the measuring device set the relative plane coordinates of this point to zero. Move the tool to the safe area, manually move the tool downward by 50mm, set the relative plane coordinates of this point to zero again, and this point is the zero position of Z axis.

5、Start production processing

When implementing each program process, you need to check carefully whether the tool used is the specific tool in the specific instruction book. Gradually production processing to boring rate to small, each section of the implementation, rapid and accurate positioning, drop tool, go tool when the need to centralize the spirit of substance, the hand should be put on the termination key any problems immediately terminate, pay attention to the observation of the tool fitness movement orientation to ensure the safety of the tool, and then gradually greater go tool rate to suitable, at the same time to the tool and workpiece to add freezing liquid or cold air.